12
PLASMA 5
| BIKE OWNER’S MANUAL 2015
BIKE OWNER’S MANUAL 2015 |
PLASMA 5
13
E
N
G
LI
S
H
E
N
G
LI
S
H
FORK
Setup screw:
front end height can be set to adjust the front wheel tire clearance with the frame
thanks to the fork dropout screws M5 (511). The fork (200) length can be set from
370mm to 380mm.
- Loosen the screws to set a higher front end
- Tighten the screws to set a lower front end.
Make sure right and left side are set at the same length by assembling the front
wheel and verifying it is centred with the fork crown.
Drop out adjustment screws: Standard M5*10mm headless screw available in any
hardware shop.
IMPORTANT
Make sure the inner diameter bearing chamfer is positioned onto the fork bearing
seat cone,
place the stem (301A/B) into the frame headtube cut-out, place the fork
(201) into the headtube, push the fork (201) from below so that the steerer tube goes
through the stem 1” hole.
Put the upper 1” bearing (902) into the headtube upper bearing seat on top of the
headtube
IMPORTANT
Put the upper 1” bearing (902) into the headtube upper bearing seat on top of the
headtube,
make sure the outer diameter bearing chamfer is positioned upon the
headtube bearing seat chamfer.
IMPORTANT
Put the 1” compression ring (903) on the steerer tube, make sure the compression
ring chamfer is positioned onto the 1” upper bearing inner diameter chamfer (face
down), put the top cap (904) on the top of the headset and tighten the M6 screw
(907) to the specified torque (T17), place the two M5 screws (303) into the recesses
located at the rear end of the stem body (301A/B), slide the stem on the steerer tube
to achieve its
correct positioning, and make sure it does not touch the frame at any
point,
tighten up the screws (907) to the specified torques (T1).
Once the cable routing is done, place the headtube cap (905) on the top of the
headtube and tighten the M4 screw (906) to the specified torque (T18).
Headset compression kit SCOTT part number: 239282
Headset Syncros Drop-In 1” - 1 1/8” SCOTT part number: 238601
HEADSET/STEM BODY TT5
Headset/Stem body assembly:
put the compression kit (908) into the steerer tube and tighten the bolt to the
specified torque (T16) , position the lower 1”1/8 bearing (901) onto the fork (201)
bearing seat
