10
PLASMA 5
| BIKE OWNER’S MANUAL 2015
BIKE OWNER’S MANUAL 2015 |
PLASMA 5
11
E
N
G
LI
S
H
E
N
G
LI
S
H
CABLE ROUTING:
FOR MECHANICAL SHIFTING
Rear Derailleur (RD) Cable Housing:
IMPORTANT
To avoid any damage to the frame structure put a housing end plug at the end of
the housing.
Place the RD cable housing into the headtube long hole, push the housing until it
touches the rear end of the headtube (you may feel a resistance), orient the housing
up and push the housing again, it will then follow the headtube down and continue
its travel along the downtube, continue running the cable housing into the frame until
it is visible from the bottom bracket opening.
Route a derailleur cable into the right dropout exit hole until it is visible from the
bottom bracket opening, feed the cable into the cable housing and lead the housing
to the right chainstay inner structure, pull the housing along the cable until it shows
from the right dropout exit hole, leave approx. 150mm of cable housing outside
the frame.
Rear Brake (RB) & Front Derailleur (FD) Cable Housings:
IMPORTANT
To avoid any damage to the frame structure put a housing end plug at the end of
the housing.
Place the housing into the headtube long hole: RD housing = left /
RB housing = middle / FD housing = right, push the housing until it touches the
rear end of the headtube (you may feel a resistance), direct the housing up and
push the housing again, it will then follow the headtube down and continue its
travel along the downtube.
Continue running the cable housing into the frame, once the housing is visible from
the bottom bracket opening, lead the housing to the bottom bracket exit hole on
the underside of the downtube in front of the bottom bracket, pull the housing to
leave approx. 100mm of cable housing outside the frame.
Front Brake (FB) Cable Housing:
refer to the Stem/Handlebar section.
Front derailleur cable guide:
IMPORTANT
for mechanical shifting only
position the front derailleur housing into the cable guide cavity, bend the housing
and position the cable guide pin into the corresponding positioning hole on the low
side of the bottom bracket, place the M4 sunk head screw into the cable guide recess
hole, tighten up the screw at the specified torque.
Front derailleur cable exit:
route the front derailleur wire/liner through the frame front derailleur exit hole, put
the wire/liner into the cable exit rubber part slot, slide the cable exit rubber part
along the wire/liner, plug the cable exit part into the frame exit hole.
Front derailleur BB cable guide (801) SCOTT Part number: 239181
