Scott Safety Protege, Руководство пользователя

Страница: 49 / 104

Configuration and Setup Checklist
25
SCOTT SAFETY 087-0038 REV L
•
CO, H
2
S, O
2
, and Combustible/LEL – Use the up and down arrows to adjust set
points for each alarm as desired.
•
Options – Provides the following items:
•
Password – A 4-digit password may be used to limit entry into the Span
calibration of the device. Select the check box that says USE PASSWORD and
enter a 4-digit number into the box. Once written to the device, everyone who
attempts to Span calibrate the device must enter this password. The default
setting is unchecked.
•
Enable Latching Alarms – When checked, this option requires you to
acknowledge all alarms even when the target gas concentration returns to a
non-alarm concentration level. The default setting is unchecked.
•
On/Off Hold Timer – Sets the required time in seconds for you to hold the
Operation Buttons when powering on and off the device. The default setting is
4 seconds.
Figure 21 shows the Set Clock Tab screen.
Figure 21 Scott Gas Monitor (SGM) Software Set Clock Screen
The following options are available:
•
Synch with PC Clock – Allows you the option to synchronize the device’s internal
clock with the PC clock.
•
Get – Reads the time setting of the device presently connected and displays it on
the SGM Set Clock dialogue box.
•
Set – Uploads the time displayed on the SGM Set Clock dialogue box to the device
presently connected.