Final Check List/Initial Start Up
1. Check that electrical power has been supplied.
2. Check that a drain, separate from the ice
machine, insulated and made of rigid tubing, has
been connected to the dispenser.
3. Check that the ice machine has been properly
installed per the ice machines installation
directions.
4. Check that the ice machine/dispenser assembly
is level front to back and left to right.
5. Check that optional kits, if any, have been
correctly installed.
6. Check that the sink key, and coin box key if
used, are available.
To Start:
1. Connect electrical power.
2. Go thru ice machine start up procedures. Let ice
machine make two harvests.
3. Push vend switch button in.
4. Rotor should rotate 1/4 turn and stop.
5. Ice will be dispensed from ice chute.
6. Remove sink, and check drain area for leaks. If
none, replace sink.
7. Fill out the warranty registration form and place
it in the mail.
8. Give the operator the key(s) and instructions on
the operation and maintenance of the product.
Check that the operator knows who to call for
service, and has the product/service manuals for
the machines.
Electrical Sequence
Pushing the vend button closes a contact to the
gear motor (and to the ice door solenoid of
SLD150-1B models).
SLD150-1 model: When the gearmotor begins to
turn, the cam switch on the gearmotor closes, so
that the vend switch may be released without
interrupting the vending, until the cam has moved
1/4 turn. The cam switch then opens to terminate
the vend.
SLD150-1B model: The gearmotor and ice door
solenoid will have power and the dispenser will
continue to operate as long as the dispense switch
is pushed in. This model also has a agitation cycle
of 3 seconds every 2 hours. The solenoid does not
engage during agitation and no ice is dispensed.
SLD150
October 1996
Page 7
