Key Kit Installation: (KSLDK2)
1. Disconnect electrical power
2. Remove sink and drain pan.
3. Remove cover.
4. Remove control box cover
5. From kit, locate brass fitting. Obtain typical door
lock cylinder from the motel/hotel.
6. Insert cylinder into brass fitting (most cylinders
will fit). Mark place where cylinder sticks out past
brass fitting. Cut off excess cylinder.
7. Insert cylinder into hole on plate in kit. Place
switch mounting bracket behind cover plate and
over fitting, with the switch below the fitting. Using
the locknut provided, fasten the fitting in place with
the flats vertical.
8. Place the cylinder in the brass fitting, and
secure to the fitting with the set screw.
9. Push hotel/motel key into the cylinder and
adjust lever of micro switch so the switch closes
when the key is pushed all the way in.
10. Install plate and switch assembly into
dispenser. Secure with nuts removed from original
plate.
11. Remove wire #8 from normally open terminal
of the dispenser switch and reconnect it to the
normally open terminal of the room key
microswitch.
12. Disconnect wire #9 from the normally open
terminal of the dispense switch and connect it to
the normally open terminal of the room key switch.
13. Use wire #6 from kit, and connect the normally
open post of the dispense switch and common of
the room key switch
Install control box cover.
Replace drain pan and sink.
Reconnect power and check vending. Pushing key
in and holding vend button down should start vend.
Electrical Shock Hazard.
Disconnect electrical
power before beginning
procedures.
SLD150
October 1996
Page 6
