Removal and Replacement
Gear Motor
1. Disconnect electrical power
2. Locate key and remove sink.
3. Disconnect wires at gearmotor
4. Mark position of cam switch bracket, and
remove bracket with cam switch from gearmotor.
5. Remove 4 nuts securing gearmotor base o
cabinet.
6. Pull gearmotor down and out of cabinet.
7. Remove gearmotor from base.
Reverse to reassemble.
Drive Shaft
1. Remove all of the ice stored inside the
dispenser bin and shut off the ice maker.
2. Disconnect electrical power
3. Locate key and remove sink.
4. Remove top front panel (in front of ice machine).
5. Remove the front top panel (above ice chute).
6. Reach into the opening, locate the large nut
securing the wheel to the drive shaft. Remove the
nut.
7. Disconnect wires at gearmotor.
8. Mark position of cam switch bracket and remove
bracket with cam switch from gearmotor.
9. Remove 4 nuts securing gearmotor to cabinet.
10. Pull gearmotor down and out of cabinet.
11. Remove six cap screws holding drive shaft
housing to cabinet.
12. Pull drive shaft housing from the bin.
13. Remove snap ring from end of drive shaft, and
tap shaft out of bearings with plastic headed or
dead blow hammer.
14. Reverse to reassemble.
Dispense Wheel
1. Remove all of the ice stored inside the
dispenser bin and shut off the ice maker.
2. Disconnect electrical power.
3. Remove ice machine from dispenser.
4. Remove large dispenser top panel.
5. Reach into the opening, locate the large nut
securing the wheel to the drive shaft. Remove the
nut.
6. Pull the wheel off the drive shaft and remove it
from the dispenser.
Reverse to reassemble.
Electrical Shock Hazard.
Disconnect electrical
power before beginning
procedures.
SLD150
October 1996
Page 11
