20. Place the the S.S. Ring on the shaft end
first….
…...then the spring ring with the inside spring
facing the S.S. ring.
21. Clean the inner surface of refrigerant manifold
carefully. Check to see the good condition of the
seal ring and fit it in its seat inside the refrigerant
manifold. Fit on shaft end the washer which keeps
in place the seal ring inside the refrigerant
manifold and fit inside the manifold the gasket.
22. Position the manifold on the six mounting
studs, fit the six mounting nuts and washers and
tighten all them down by means of a 10 mm.
wrench.
23. Connect the outlet refrigerant line to the
corresponding port of the manifold and tighten it
with the four head recessed screw.
24. Connect the refrigerant inlet line on its
manifold fitting and tighten the fitting flare nut.
MAR1400 & MAR2000
December 2000
Page 28
