Unpacking
Remove the carton from the skid. Check for hidden
freight damage, notify the carrier immediately if any
is found. Retain the carton for the carrier’s
inspection.
The machine is not bolted to the skid. If strapped
remove the strap.
Place on Bin or Dispenser
If reusing an existing bin, be sure that the bin is in
good shape and that the gasket tape on the top is
not torn up. Water leaks, not covered by warranty,
could result from a poor sealing surface. Because
this is a remote low side, a new bin is
recommended due to the high cost to the user of
replacing an old bin when a remote system is on
top.
Install the correct adapter, following the directions
supplied with that adapter.
Hoist the machine onto the adapter.
Note: The machine is heavy! Use of a mechanical
lift is recommended.
Position the machine on the bin or adapter. Secure
with straps from the hardware bag packed with the
machine, or those supplied with the adapter.
Remove any plastic covering the stainless steel
panels.
Note: The standard machine set up includes visible
on and off switches. Those can be covered up by
changing the bezel in the front panel’s trim strip. A
cover-up bezel is included with the hardware bag.
Remove any packaging, such as tape or foam
blocks, that may be near the gear reducer or ice
chute.
Level the bin and ice machine front to back and left
to right by using the bin leg levelers.
Panel Removal
1. Locate and loosen the two screws at the front
edge of the top panel.
2. Pull the front panel out at the top until it clears
the top panel.
3. Lift the front panel up and off the machine.
4. Remove two screws at the front of the top panel.
Lift up the front of the top panel, push the top panel
back an inch, then lift to remove.
5. Locate and loosen the screw holding each side
panel to the base. Left side panel also has a screw
holding it to the control box.
6. Pull the side panel forward to release it from the
back panel.
Button
Switch Bezel
To change bezels: Remove the front panel, and
refer to the instruction label on the inside of the
front panel. Push snaps of standard bezel in and
pull the bezel out of the front panel trim strip.
Locate other bezel. Push into the trim strip from the
front until it snaps into place. Return the front panel
to its original position and secure it to the cabinet
July 2009
Page 5
N0622L, F0822L, N0922L, F1222L, N1322L, F1522L
Remote Low Side User's Manual
