Maintenance And Cleaning Instructions
GENERAL
The periods and the procedures for maintenance
and cleaning are given as guides and are not to be
construed as absolute or invariable. Cleaning,
especially, will vary depending upon local water
and ambient conditions and the ice volume
produced; and, each ice machine must be
maintained individually, in accordance with its
particular location requirements.
Ice Machine
The following maintenance should be scheduled at
least two times per year on these ice machines.
1. Check and/or replace the water filter (if used).
2. Check that the ice machine is leveled in side to
side and in front to rear directions.
3. Check for water leaks and tighten drain line
connections. Pour water down bin drain line to be
sure that drain line is open and clear.
4. Check size, condition and texture of ice cubes.
Perform adjustment of cube size control as
required.
5. Check the bin thermostat to test shut-off.
Put a scoop full of ice cubes in contact with the bin
thermostat bulb for at least one minute.
This should cause the ice maker to shut off. Within
few seconds after the removal of the ice from bin
thermostat bulb, the ice machine restarts.
NOTE. Within minutes after the ice is removed
from the bulb holder tube, the sensing bulb inside
the tube will warm up and cause the ice machine
to restart. This control is factory set and should not
be reset until testing is performed.
6. Check for refrigerant leaks.
NOTE. Standard equipped with an air condenser
filter as well as a Cleaning Reminder Board to
remind to the end user the need for the cleaning of
the air filter or of the water system (Red Alarm
Light ON Steady or Blinking respectively with
machine in operation).
Clean - Replace Of Air Condenser Filter
1. Withdraw the air filter from the front through the
opening of the front panel.
2. Remove the front panel.
3. Blow pressurized air on the opposite direction of
the condenser air flow so to remove the
dust accumulated. If pressurized air is not
available, use tap water always in the counter flow
air direction. Once cleaned shake it so to remove
most of the accumulated water, then dry it using an
hair dryer.
NOTE. In case the air filter strainer is damaged
replace it with a new one.
4. Return the front panel to its normal position.
5. Install filter by pushing it through the front panel
opening.
CU0515
April 2007
Page 12
