SR-i800
Motorcycle Security System
INSTALLATION MANUAL
AND USER’S GUIDE
Table of Contents
Installation
•
Component List ----------------------------------------------------------------
Page 3
•
Planning The Installation ----------------------------------------------------
Page 3
•
Mounting The Components -----------------------------------------------
Page 4
•
Color Codes ---------------------------------------------------------------------
Page 5
•
Connections ---------------------------------------------------------------------
Page 5
•
Using the T-tap ------------------------------------------------------------------
Page 6
User’s Guide
•
Standard Features ------------------------------------------------------------
Page 2
•
Transceiver Battery ------------------------------------------------------------
Page 3
•
Violation Display ---------------------------------------------------------------
Page 6
•
Operating the transceiver --------------------------------------------------
Page 7
•
Adjusting G Sensor ------------------------------------------------------------
Page 7
•
Selecting Arming Modes ----------------------------------------------------
Page 7
•
Alarm Triggers -------------------------------------------------------------------
Page 8
•
Manual Override Code -----------------------------------------------------
Page 8
•
Encoding a Transceiver -----------------------------------------------------
Page 1
•
Troubleshooting Guide -------------------------------------------------------
Page 10
Accessories
•
Optional Accessories ------------------------------------------------------
Page 2
•
Perimeter Sensor (SN-5) ------------------------------------------------------
Page 9
Warranty and FCC Information
•
Limited Warranty -------------------------------------------------------------
Page 11
•
FCC Notice ----------------------------------------------------------------------
Page 11
•
Contact information ----------------------------------------------------------
Page 11
Encoding a Transceiver
1.
Unplug HAR-1 from the MCM-9 and plug it back in, the siren will chirp 2 times and
the lights will flash 2 times.
2.
Within
6 seconds
of plugging in the HAR-1, turn ignition switch “ON” and “OFF” 3
times.
3.
If step 2 is done correctly and within the time allowed , the siren will chirp 2 times
and the lights will flash an additional 2 times to confirm that the system is in
“Learn Mode”.
4.
Press and hold the button until the system chirps 2 times and the lights flash 2
times to indicate that the MCM has learned the code.
5.
Turn ignition “ON” and “OFF” to exit “Learn Mode”.
**It is not recommended to clip the remote to your ignition key. Attaching the
remote to your key may damage the remote and/or scratch your bike**
1
Note: The transceivers are programmed from the factory. Encoding is only necessary should
the transceiver lose its code and will not arm or disarm the security system or if a
replacement remote is obtained.
