Connections
Fuse
To Battery (+)
Accessory
HAR-1 Connector
GEN-1
MCM
Black – To Ground (-)
Grey – To Turn Signal
Grey – To Turn Signal
Orange – To Tail Light
Note: Connect the (HAR-1) harness to the MCM only after installation is completed. If the
battery is to be removed, disconnect this connector first. Reconnect only after battery
terminals are reconnected.
Note: When the main harness (HAR-1) is plugged in, the siren should chirp. If the siren dose
not chirp; check the fuse, and battery (+) and ground (-) connections.
Using the T-tap Connectors
1) Place female T-tap connector over wire to be tapped, close and squeeze until it snaps close.
2) Now slip male T-tap connector over hinged end of the female connector to make a
connection.
Motorcycle Wire
1)
Female T-tap
2)
Female T-tap
Male T-tap
Motorcycle
Wire
Wire from (GEN-1)
4
