Scorpio Miss Acro S2066, Руководство пользователя

Страница: 4 / 16

Miss Acro S2066
remove the unused gearbox “ears” from the gearbox.
MPJ-2[ ] Measure the distance between the holes for
the mounting screws (not supplied) on the adapter.
Mark this dimension on the front bulkhead of the
fuselage and drill 3mm holes for the mounting screws.
MPJ-3 [ ] Screw the motor/gearbox assembly into
place.
MPJ-4 [ ] The output shaft of the gearbox should
have about 5° of downthrust and 2° of sidethrust. Use
ply shims to adjust as required.
Horak and similar gearboxes
MH-1 [ ] Assemble the motor cradle gluing
together its parts.
MH-2 [ ] Put the motor cradle into the forward part
of the fuselage, add the motor and check for the
alignment of the motor shaft with the hole in the
fuselage front former. When the alignment is correct,
epoxy the cradle into the fuselage.
MH-3 [ ] Fasten the motor to its cradle using a
plastic tie strap.
MH-4 [ ] Glue the mounting plate into place so
that the output shaft of the gearbox is central to the
hole in the nose of the fuselage.
MA-5 [ ] Screw the motor/gearbox into place, and
attach the propeller.
Finishing
FT-1 [ ] Recommended layout of radio and drive
system in Miss Acro.
FT-2 [ ] Electronic schematic of the parts installed
in Miss Acro.
FT-3 [ ] Check that the control surface movements
are correct. The elevator movement should be about
20° up and down. Rudder should be about 30° left and
right and ailerons about 20° both directions.
FT-4 [ ] Add the supplied decals to the model as per
the box illustration.
FT-4[ ] Check the balance point. It must be between
55 and 60 mm back from the leading edge of the
wing. If necessary, move the batteries inside the
fuselage to balance.
Safety Warning!
Your Miss Acro is a relatively
safe R/C model. It may be flown in fairly small areas
without disturbing your neighbours. Never forget that it
is not a toy and that it could be potentially dangerous
if common sense is not used. Avoid flying in
populated areas or close to roads, railways, airports
and so on. Ensure that any spectators are aware of
the potential danger of your model.
Enjoy flying your Miss Acro !
Box Parts
No. Qty. Description
[1] 1 Fuselage
[2] 1 Right Wing
[3] 1 Left Wing
[4] 1 Rudder complete
[5] 1 Tailplane complete
[6] 1 Canopy
[7] 1 Main Landing Gear
[8] 2 Fuselage doublers
1 Bag B1
1 Bag B2
1 Bag B3
1 Die Cut DC-1
1 Die Cut DC-2
1 Die Cut DC-3
1 Die Cut DC-4
1 Die Cut DC-5
1 Decals
1 Instruction Booklet