scoole SC HT CL1 1000 WT, Инструкция по эксплуатации

Страница: 10 / 44

Operation of SC HT CM1 series electric convectors
1. Switching on
Insert the plug of the power cord to the receptacle to connect the convector to the electric mains.
2. Selection of heating power modes*
Using the power mode switch knob, set the desired heating power: low power ("ECONOMY"), high
power ("EXPRESS").
* - Except for SC HT CM1 1000 WT model
3. Temperature setting
Turn the thermostat knob clockwise up to the stop to the "MAX" position. If the room temperature is
below the set value, "HEATING" indicator should light up. When the room temperature reaches the
desired level, turn the thermostat knob counterclockwise until the appliance switches off.
10
1. Heating power mode switch knob*
This knob is used for selection of the following heating power
modes: low power ("ECONOMY"), high power ("EXPRESS").
2. "POWER" indicator
This indicator lights up upon connection of the appliance to the
electric mains.
3. "HEATING" indicator
This indicator lights up upon switching of heating on.
4. Thermostat knob
This knob is used for setting of the desired temperature in the
room.
* - Except for SC HT CM1 1000 WT, which have one heating power and
use one-key switch
Fig . 4
Control panel for convectors of SC HT CM1 series (Fig. 4 )
3
4
2
1
INSTRUCTION MANUAL