7.0
Front Panel Button Control
The matrix can be controlled using the buttons on the front panel. On completion of each command the buttons
used will flash three time to confirm your selection. If the command was not accepted or failed the button will go
off immediately.
User Manual
Scion Tech
SC36.MX88
7.1
Signal Switching
●
Switch an input to an output
Operating: INPUT# + OUTPUT# + ENTER
●
Switch an input to several outputs
Operation: INPUT# + OUTPUT# + OUTPUT# + OUTPUT# + ENTER
●
Switch an input to ALL outputs
Operation: INPUT# + ALL + ENTER
●
Current Switching Status
Operation: Press the OUTPUT# and the corresponding input LED will illuminate.
Note: The factory default status sets all IR outputs to the corresponding HDMI inputs. When you switch a HDMI
input the corresponding IR output will be switched synchronously.
7.2
Locking / Unlocking Panel Buttons
●
Press and hold the “Lock” button from three seconds to lock or unlock.
7.3
Preset Settings
The matrix supports nine presets but only 1~4 can be set or recalled using the front panel buttons. RS232 or
TCP/IP GUI should be used to set and manage all presets.
Press and hold preset 1~4 for three seconds to save the current switching status to the chosen preset button.
Press preset 1~4 to recall the saved preset.
Press CLEAR to cancel an operation before pressing ENTER.
Page 11
Tel: +44 (0) 1635 862484
www.scion-tech.co.uk
