scigiene NV-N20K48, Руководство пользователя

Страница: 32 / 56

32
/57
pass
Password
Allows you to enter the password.
This parameter is displayed before the protected cycles. See CONFIGURATION PROTECTION section.
Calib
Calibration
Allows you to calibrate the analog input.
in.LC
input Low
Calibration
Value corresponding to the low scale signal applied to the analog input. See INPUT CALIBRATION
section. This parameter will be displayed if you set the Calib parameter to YES .
in.HC
input High
Calibration
Value corresponding to the full-scale signal applied to the analog input. See INPUT CALIBRATION
section. This parameter will be displayed if you set the Calib parameter to YES .
R.CAL
Restore
Calibration
Allows you to restore factory calibrations, erasing all changes made.
R.Cfg
Restore
Configuration
Allows you to restore factory settings, erasing all changes made.
Pas.C
Passwo
rd
Chang
e
Allows you to set a new password, always different from 0 (zero).
Prot
Protection
Allows you to configure the Protection Level. See CONFIGURATION PROTECTION section.
FREQ
Frequency
Allows you to set the mains frequency: 50 Hz or 60 Hz.
CTr.E
Control
Enabled
If set to yes , allows the Control parameter ( Ctr ) to be displayed (and set) in the Operation Cycle. See OPERATION
CYCLE section.
PRG.E
Progra
m
Enable
d
If set to yes , allows the Programs parameter ( PRG ) to be displayed (and set) in the Operation Cycle. See
OPERATION CYCLE section.
RUN.E
Run Enabled
It set to yes , allows the RUN parameter to be displayed (and set) in the Operation Cycle. See OPERATION CYCLE
section.
BLE.E
Bluetoo
th
Enable
d
If set to yes , allows the Bluetooth interface of the device to connect to the Bluetooth interface of the smartphone
being used (see BLUETOOTH INTERFACE section).
Once the connection between the device and the smartphone has been successfully made, the controller will
show a Bluetooth flag on its display (see
DISPLAY INFORMATION section).
You must use the QuickTune Mobile application to configure the controller through the Bluetooth connection with a
smartphone (see CONFIGURATION SOFTWARE chapter).
SnH
Serial
Number High
Displays the first four numbers of the device serial number.
SnL
Serial
Number Low
Displays the last four numbers of the device serial number.
Table 15
–
Calibration cycle