7
The device is supposed to put the place where contains low humidity, little dust, well-ventilated,
avoiding water and sunshine or strong direct light or corrosive gas or high intensity magnetic field or
heating or fire or other heat source.
Power Switch. Press “ I ” , power on. Press“ O ” , power off.
Power Input is DC24V, center of socket is “+”, outer ring is “-”.
Power off when you do not need to use it. Pull out power socket if you will not use it in a long time.
Cover it with soft cloth or plastic paper to avoid dust.
4. Operation Procedure
4.1 Set up a new Procedure:
Power on and then system comes to operation
interface. Press Start/Stop key over 2 minutes,
then is goes into Setting up Procedure interface.
You can DIY 9 procedures, P1 to P9. Each
procedure includes 3 sections/move (A, B, C).
-----28.7-----
4.2 Set up S.N. of Procedure：
Cursor will point ID number of procedure by
quickly pressing P key, then you can select ID
number and section of procedure (A, B, C) by
▲
or
▼
.
P2-A 55.5 095
4.3 Set Temperature：
Cursor will point temperature by quickly pressing
Temp key, then you can change temperature by
▲
or
▼
.
4.4 Set Time：
Cursor will point time by quickly pressing Timer
key, then you can change time by
▲
or
▼
.
Quickly press
▼
when time parameter value
equals to 000. Time parameter value at OFF
means this procedure will not run.
P2-A 55.5 032 s
P2-A 75.5 OFF
P2-A 55.5 095 M
P2-A 75.5 032 M
