Assembly 3.10
SCIFIT Scientific Solutions For Fitness SCIFIT Scientific Solutions For Fitness SCIFIT
5b.
Route the Main, CHR and E-Stop cables through the
exit hole on the console mounting bracket, then align the
mounting bracket holes with the console mounting holes .
Tool Required:
Hardware Required:
Phillips screw driver
(
Qty. 4) M5 x .8 x 12mm
Phillips HD Screw
5c.
Take the ring lug end of the Magnet/Clip tether and
using a phillips screw driver secure it to the lower left corner
of the console mount weldment with (Qty. 1) M5 x 12mm of
the screws previously removed in step 5a .
6a.
Pull out the Main, CHR and E-Stop cables from the
machine center frame and connect them to the Main, CHR
and E-Stop extension cables coming from the console.
6b.
After connecting, push all the cables back into the
center frame and align the two console mounting bracket
holes with the two center frame mounting holes..
STEP 5: ATTACH THE CONSOLE MOUNT WELDMENT TO CONSOLE
5a.
Remove the four screws that are inserted into the rear
enclosure of the console and place to the side.
STEP 6: ATTACH CONSOLE WITH MOUNTING BRACKET TO THE UPRIGHT ASSEMBLY
5d.
Using a phillips screw driver finish securing the console
mount weldment with (Qty. 3) M5 x 12mm phillips head
screws previously removed in step 5a.
Pull cables out
from center frame
Connect cables here,
then push them into
the center frame
Console
Mounting
Bracket
M5 x 12mm Screw
To Secure Ring Lug
Exit Hole
Magnet/Clip
Ring Lug
Secure Console
Mount With
Remaining
M5 x 12mm
Screws
