Scientific
SM6015A
18/44
Minimum
Display
Press REC button until the “ MIN ” indicator is shown on display. This indicates that
the value in the primary display represents the recorded minimum value.
Average Display
Press REC button until the “AVG ” indicator is shown on display. This indicates that
the value in the primary display represents the recorded average value.
Disable Static Recording
To exit this mode, press and hold the REC button for a long time. The “MAX”, “MIN”,
or “AVG” indicator will disappear on LCD.
NOTE:
Changing the type of test parameters will
automatically turn off static
recording.
6.3 PRI Select Mode
To select measurement mode, you should select primary parameter first.
Each press of the L/C/R/Z button, the parameter will change and repeat as the
following modes: L (inductance), C (capacitance), R (resistance) and Z (impedance)
NOTE:
After changing primary mode, secondary
display indicates the present
frequency. If it is required to display corresponding secondary parameters, press the
secondary button.
6.4 SEC Select Mode
If necessary, press the D/Q/
θ
/ESR button to select secondary parameters.
Each press of the D/Q/
θ
/ESR button, the following modes will be displayed on the
screen:
D (Dissipation factor), Q (Quality factor),
θ
(Phase angle), and ESR (Equivalent
series resistance).
6.5 Test Frequency
（
FREQ
）
SM6015A handheld LCR meter applies AC signal to DUT for measurement.
Frequency is among the main parameters of AC signal. By the presence of
component’s non-ideality and distributed parameters, the effect of distributed
parameters of test port and test lead, the test frequency used on the same
component might cause different test result. Therefore, a proper frequency should be
selected before test.
Selecting Frequency
To change the test frequency, push the FREQ button. If the secondary display does
not indicate the frequency, it will display the actual operating frequency when you
press FREQ. If the secondary display indicates frequency, at each press of the
FREQ button, the meter will change among the following selectable frequencies:
SM6015A
：
100Hz/120Hz/1kHz/10kHz
Содержание SM6015A
Страница 1: ...Hand Held LCR Meter SM6015A User Manual ...
