Scientific 170, Инструкция по установке, эксплуатации и уходу

Страница: 6 / 10

Part
No.
1 H�NDLE
2 LID COVER
3 LID COVER STIFFENER
4 B�SE TOP COVER
5 COOLING COIL
6 INNER T�NK
7 MOTOR GRID
8 F�N MOTOR
9 IMPELLER
10 CONDENSOR
11 FRONT COVER
12 OUTER ENCLOSURE
13 SOCKET
14 DRYER
15 COMPRESSOR
16 PO�ER CORD PLUG
17 V�LVE
18 PUMP HOUSING COVER
19 PUMP HOUSING BODY
20 IMPELLER
21 PUMP HOUSING STUDS
22 ELEMENT 1200� 230V
23 PT 100 TEMPER�TURE PROBE
24 ILUMIN�TED ROCKER S�ITCH
25 TEMPER�TURE CONTROLLER
26 B�SE P�NEL
27 CIRCUL�TING MOTOR �SSEMBLY
28 EXTERN�L PUMP CONNECTION P�RT �
29 EXTERN�L PUMP CONNECTION P�RT C
30 EXTERN�L PUMP CONNECTION P�RT B
31 EXTERN�L PUMP BRIDGE P�RT �
32 EXTERN�L PUMP BRIDGE P�RT B
33 HE�T SINK
34 SOLID ST�TE REL�Y 25�MP
35 PO�ER CORD
36 C�BLE GL�ND
37 INLINE RESET�BLE FUSE
38 CH�SSIS
39 COVER PL�TE
40 F�CI�
Description
MODEL: COOLING CIRCULATING BATH
MODEL CODE : 170 R00
OPERATING INSTRUCTIONS OF ELECTRONIC TEMPERATURE
CONTROLLER
1. The temperature controller has four buttons on the front face.
These are used to set the required temperature� initiate �uto-
Tuning� and enter any adjustments to the program.
2. To set the required temperature� ensure that the unit is con-
nected and switched “ON” in the appropriate manner.
3. The top display (red) shows the actual temperature (PV) in the
unit� the bottom display (green) is the setting temperature
(SV) and must be adjusted to the required temperature. To
adjust the setting� press the button that points to the left.
This action will start one of the digits in the lower display flash-
ing. By touching this button again� the flashing will move to the
left. Once the flashing red display is on the number that needs to
change� use the UP/DO�N buttons to attain the required set-
tings.
4. By moving the flashing digit left or right the desired temperature
required can be set. Once the correct temperature has been en-
tered� press SET to enter the setting.
3 12