WebSTAR DPX2203C and EPX2203C VoIP Cable Modem User’s Guide
40
Mounting the Cable Modem on a Wall
To mount the cable modem on a wall
Complete these steps to mount the cable modem on the wall.
1. Using a drill with a 3/16-in. bit, drill two holes in the wall at the exact same
height and 4 inches apart.
Note:
The graphic on the preceding page illustrates the location of the
mounting holes on the back of the cable modem.
2. Are you mounting the cable modem into a drywall or concrete surface where
a wooden stud is available?
•
If
no
, drive the anchor bolts into the wall, and install the mounting screws
into the anchor bolts leaving a gap of about 1/4-in. between the screw
head and the wall. Then, go to step 4.
•
If
yes
, go to step 3.
3. Install the mounting screws into the wall leaving a gap of about 1/4-in.
between the screw head and the wall. Then, go to step 4.
4. Verify that no cables or wires are connected to the cable modem.
5. Lift the cable modem into position. Slip the large end of both mounting slots
(located in the back of the cable modem) over the mounting screws, then
slide the cable modem down until the narrow end of the keyhole slot contacts
the screw shaft.
Important:
Verify that the mounting screws securely support the cable
modem before you release the unit.