6
Mechanical Service Procedures
Note:
Your machine may not match the image. For reference only.
Tools required:
pedal wrench, #2 Phillips screwdriver, 11mm open
end wrench or socket and wrench (or nutdriver)
1.
Remove the Pedals. Refer to the “Replacing the Pedals”
procedure in this manual.
2.
Carefully remove the Shrouds, Console and Vent Cover. Refer
to the “Replacing the Shrouds and Vent Cover” procedure in this
manual. Set the hardware safely aside for reassembly.
3.
Remove the Rear Fan Covers. Refer to the “Replacing the Fan
Covers” procedure in this manual. Set the hardware safely aside
for reassembly.
4.
To tighten or loosen the tension, turn the adjustment bolt (A) on
the back of each Fan Tensioner bracket (B).
NOTICE:
Be sure to adjust the tension evenly on the two sides.
5.
Before you reinstall the Fan Covers, make sure that the belt
tension is correct. Refer to the “Belt Tension Adjustment”
procedure in this manual.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
Fan Tension Adjustmennt
Disconnect the data cable from the console before you service this machine.
(Connector Arm not shown for clarity)
A
B
