24
USER MANUAL HG1000 532
7.3. Bedientasten der Fernbedienung
ALERT
DISARM
ARM
HOME
ALERT
By pressing the
ALERT
button, the centre switches into doorbell mode. In this case, upon
being set off by a sensor, a doorbell noise (“ding dong”) sounds.
HOME
By pressing the
HOME
button, the centre switches into home mode.
PANIC
Pressing the
HOME
and
ALERT
buttons at the same time sets off an alarm immediately.
ARM/DISARM
Using these buttons, you can activate (
ARM
) or deactivate (
DISARM
) the system.
7.4. Deletion of remote controls
If a remote control has become damaged or lost, this can be deleted from the system as follows.
Step 1
Step 2
Step 3
You must be in Standby Mode.
Now enter
“1-2-3-4”
or your
newly set PIN
and confirm this
with
.
If you enter the PIN correctly, the
display now shows the following
image:
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 4
Step 5
Step 6
Now press
followed by the
“5”
button, in order to get into the
delete mode.
In the display, now, the total
number of remote controls that are
integrated into the system, flashes.
(e.g. in the case of 3 registered
remote controls, “03”)
Now enter the ID number of the
remote control that should be
deleted via the operating buttons,
e.g. “02”.
➜
If 00 is entered, all registered
remote controls are deleted.
Step 7
Step 8
In the LCD display, now, the
total number of the other remote
controls that remain in the system
flashes.
(An additional beep gives acoustic
feedback about the successful
deletion remote control)
Confirm the setting using
.
The centre now automatically
switches into the Standby Mode
again.
