C1000 & C2000 Assembly Instructions
14
www.schuttsports.com
800-426-9784
Base Assembly - C2000
continued...
Step 1:
Push two brackets
(1)
down to
raise brake feet and lower wheels.
Step 2:
Remove four countersunk
screws from lower padding. (Lower
padding has six sides.)
Step 3:
Attach padding
(2)
to underside
of brackets using screws.
NOTE:
Operate brake feet and wheels
as follows:
• To lower brake feet and raise wheels,
push up on padding until red lever
latches.
• To raise brake feet and lower wheels,
release red lever; pull out on
padding, and rotate padding down
completely.
Step 4:
Remove strap that holds main
post in place. Do not remove strap that
holds slider post in place.
CAUTION:
Pinch points can crush
fingers. To prevent serious injury,
avoid all pinch points by grabbing
handle on main post back side with
both hands when lifting post into
place.
Step 5:
Grab handle on main post
(3)
back side, and lift post until it snaps
into place. Tighten 1/2" nut
(4)
between
top of main post
(3)
and mast
(5)
to
lock assembly.
1
3
4
5
2
