SCHUNK VERO-S, Сборка и руководство по эксплуатации

Страница: 46 / 74

Assembly
46 03.00|WDP-5X |en
CAUTION
Notes on clamping pins and mounting screws
The holding force of the quick-change pallet system is limited
essentially by the tightness of the screw connection, which
connects the clamping pin to the pallet or the device.
• This is why only screws of strength class 12.9 may be used.
• Only original SCHUNK clamping pins may be used.
• If the clamping pins are to be used in customer-owned
devices, the customer must provide sufficiently dimensioned
threaded holes or a sufficiently thick mounting material.
The clamping pins can be attached to the workpiece or pallet in
two different ways; the mounting variants are however numbered
in the preferred order.
These clamping pins are preferably to be used with precisely
height-coordinated workpiece gradings. These do not allow any
height tolerances to be compensated to the workpiece. If height
tolerances to the workpiece are to be overcome, a compensation
module with SPC-ASM 36 height-adjustable workpiece direct
clamping pins must be used in the affected clamping area (see
chapter "Workpiece direct clamping pins for compensation
modules"
(

5.5, Page 49) ).
If clamping pins are used outside of SCHUNK pallets, for example
in customer-specific devices or workpieces, the outer diameter of
the part to be clamped must be large enough to completely cover
the O-ring on the top of the quick-change pallet system.
Designation type ID min. outer diameter at the part contact
point
WDP-5X-DSM 99-70 0471603 75 mm
WDP-5X-DSM 99-70-M 0471611 75 mm