Assembly
04.00|1411420_NSE mini 90-25, NSE mini 90-25-V10 |en
21
NSE-HT mini 88-20
Fasten in the installation space with 6 M4 screws.
The assembly clamping module is positioned using the centering
diameter of the installation space:
Ø73 H6
.
The air connection is normally made via the coupling
holes in the floor of the unit.
The fitting bore
Ø12 H7
can be used to position the installation
space (e.g. a clamping station). The positioning element (e.g.
positioning pin
Ø12 g6
) must not protrude deeper than 12.5 mm
into the clamping module to avoid collision with the clamping pin.
At the same time, the bore provides emergency access to the
clamping pin screw if the clamping pin was screwed from below
. In the event of a malfunction, the clamping pin
can be removed from the removable installation space so that the
pallet or workpiece can be released from the clamping module
(provided that the Ø12 H7 bore is not blocked by the installation
space).
Mounting and connection
① Hose
-free direct connection "open clamping module"
← →
② Hose
-free direct connection "turbo function"
→ ←
4.3.1
