SCHUNK TANDEM KSF3 100, Сборка и руководство по эксплуатации

Страница: 32 / 48

Maintenance and care
32 02.00 | KSF3, KSF3-LH, KSF3-F | Assembly and Operating Manual | en |
1467140
Additionally for the KSF3-F variant:
Remove screw (68). Pull out the positioning
bolt (10) via its extraction thread with a screw
as far as the stop.
Pull the base jaw (9) out of the housing.
Variant "PM" also includes the O-ring (44).
Variant "PM" also includes O-ring (44),
monitoring piece (7) and compression springs
(26).
The monitoring element is adjusted and
secured with the set-screws (61, 63).
Caution! The monitoring piece is under spring
pre-load and is installed directionally oriented
for each base jaw! See detail views for jaw 1
and jaw 2!
Maintenance • Clean all disassembled parts thoroughly and check for damage
and wear.
• Treat all sliding surfaces with lubricant } 7.3 [ / 29] .
• Replace the seals of the monitoring if necessary } 8.1 [ / 35] .
Assembly Assembly is done in the reverse order of disassembly. In doing so,
observe the following:
• Pay attention to the mounting position of the base jaws (item 2)
and the chuck piston (item 3).
• Observe the tightening torques for the screws } 4 [ / 18] .