Basic safety notes
14
04.00|0889132_ROTA TB2 / ROTA TB2 LH |en
DANGER
Possible risk of fatal injury to operating personnel due to
toolholder failure if the maintenance and servicing instructions
for the toolholder are disregarded.
The servicing instructions specified by the manufacturer must be
complied with to ensure safe operation of the chuck.
Work must be carried out by qualified specialist personnel with
the relevant safety training.
Observe the maintenance instructions in this manual.
Use of special chuck jaws
When using special chuck jaws, please observe the following rules:
•
The chuck jaws should be designed to be as light and as low as
possible. The clamping point must be as close as possible to the
chuck face (clamping points at a greater distance lead to
greater surface pressure in the jaw guidance and can
significantly reduce the clamping force).
•
Do not use welded jaws.
•
If for constructional reasons the chuck jaws in special design
are heavier than the top jaws assigned to the clamping device,
greater centrifugal forces must be accounted for when defining
the required clamping force and the recommended speed.
•
Screw the jaw mounting screws into the bore holes furthest
apart.
•
The maximum recommended speed may only be operated in
conjunction with maximum actuating force and only with the
chuck in optimal, fully functioning condition.
•
If the chuck is involved in a collision, it must be subjected to a
crack test before using it again. Replace damaged parts with
original SCHUNK spare parts.
•
Replace the chuck jaw mounting screws if there are signs of
wear or damage. Only use screws with a quality of 12.9.