SCHUNK ROTA-S flex, Сборка и руководство по эксплуатации

Страница: 12 / 40

Basic safety instructions
12 06.00 | ROTA-S flex | Assembly and Operating Manual | en | 0889139
• Use a suitable high-pressure grease gun to ensure that you
reach all the greasing areas.
• To ensure correct distribution of the grease, move the lathe
chuck to its end positions several times, lubricate again, and
then check the clamping force.
• We recommend checking the clamping force using a clamping
force tester before starting a new production run and between
maintenance intervals. *Optimum safety can only be
guaranteed through regular checks*.
• The clamping force should always be measured with the chuck
in the same condition as it is used in for the current clamping
application. If top jaws with clamping steps are used, measuring
must be performed in the same step as for the respective
clamping task. In the event of high operating speeds, clamping
force losses must be accounted for due to the centrifugal force
acting on the chuck jaws. In this case the value of the operating
clamping force should be measured dynamically.
• Move the lathe chuck through to its end position several times
after 500 clamping strokes, at the latest. (This moves the
lubricant back to the force transmission surfaces so that the
clamping force is retained for longer).
Safety notes for servicing
Follow all the applicable legal standards for health and safety
during servicing. Use suitable personal protective equipment,
especially protective gloves, goggles, and safety boots - paying
particular attention to the operating system and hazard
assessment.
Immediately report any changes including operational behavior to
the competent units/persons; if necessary, immediately shut down
and secure the machine on which the lathe chuck is mounted. Do
not start up the machine that the chuck is mounted on again until
the malfunction has been eliminated.
DANGER
Possible risk of fatal injury to operating personnel due to
toolholder failure if the maintenance and servicing instructions
for the toolholder are disregarded
The servicing instructions specified by the manufacturer must be
complied with to ensure safe operation of the chuck.
Work must be carried out by qualified specialist personnel with
the relevant safety training.
Use of special chuck jaws
When using special chuck jaws, please observe the following rules: