Mounting
04.00|ROTA FSW |en
23
Assembly of the flexible adapter to the draw tube/drawbar
The item numbers specified for the corresponding individual com-
ponents relate to chapter drawings.
(Figure "Assembly of the chuck quick-change or intermediate
flange" see chapter "Checking the spindle nose of the holder of the
The flexible adapter must be designed to suit the machine and
the changing clamping devices. Only original SCHUNK attach-
ments may be used!
• Remove the flexible adapter (Pos. 9) from the packaging and
check it for damage/completeness.
• Ensure that there is either a guide ring for the draw
tube/drawbar in the machine spindle, and that it is in perfect
condition, so that a maximum axial run-out error of the draw
tube/drawbar contact surface of 0.2 mm is observed; or the
axial run-out of max. 0.2 mm is already complied with (see Fig.
"Assembly of the chuck quick-change or intermediate flange" –
E).
• Turn the actuating screw (Pos. 5) carefully clockwise as far as
the back stop. The golden indicator pins (Pos. 6) are then level
with the housing (Pos. 1).
• Actuate the clamping cylinder to move the draw tube/drawbar
to the foremost position and screw the flexible adapter in-
cluded (Pos. 9) to the draw tube/drawbar on the block.
5.4
