_________________________________________________________________________________________
www.schunk.de
XND.00018.002_A – 10/2018
28
7.3
Assembly
Carry out assembly in the reverse order.
Apply sufficient grease when assembling the spindle unit. The torque for tightening the
cylinder screws (item 90) for fitting the centring fork is 9 Nm.
Push the vice fully together so that you can
check whether the drivers (items 40/50) are
symmetrical with the tool body (item 10).
When the drivers are symmetrical, the
clamping jaws can be fitted.
Should the drivers not be symmetrical with the
tool body, the centre has to be re-adjusted!
7.4
Adjusting the centre
Tighten both cylinder screws (item 90)
with 9 Nm.
Adjust the threaded pins (item 100) on the
side such that the drivers (items 40/50) are
symmetrical in relation to
A.
When doing that it is important to ensure
that the threaded spindle (item 30) always
moves freely. (Twisting of centring fork).
When the centre has been adjusted,
use "low strength" Loctite to glue the
threaded pins in place.
A
