Basic safety notes
14
01.00| |en
Checking the behavior of personnel
The operator must at least occasionally check that the personnel
are behaving in a safety conscious manner and are aware of the
potential hazards.
Danger signs
The operator must ensure that the signs concerning safety and
hazards mounted on the machine where the chuck is mounted are
clearly legible and are observed.
Faults
If a fault occurs on the chuck and this fault endangers safety or if
a problem is suspected due to production characteristics, the
machine tool where the chuck is mounted must be immediately
stopped and remain shut down until the fault has been located
and remedied. Only allow specialists to remedy faults.
Spare parts
Only ever use original SCHUNK spare parts.
Environmental regulations
Comply with the applicable legal norms when disposing of waste.
Using personal protective equipment
When using this product, you must comply with the relevant
health and safety at work rules and you must use the required
personal safety equipment (minimum: category 2).
2-jaw chuck
The values for the total clamping force, recommended speed and
actuating force are embossed on the chuck body.
The base jaws are aligned in the front stroke position. The top jaws
only align after 10 mm of piston stroke.
Only parts that are flat in the clamping direction or on which
compensation is only expected in the jaw guidance direction can
be clamped.
2.7
2.8
