Operation
16
02.00 | GSW-M | Assembly and Operating Manual | en | 389114
5 Operation
NOTE
Using the fitting bores and threads (6), auxiliary means (e.g. for
positioning of the workpiece) can be fastened.
Hold workpiece
Ø
Place the GSW-M with the rubber friction ring (1) on the workpiece.
Ø
Lower the GSW-M further in direction of the workpiece (20
mm) until the magnet (2) is flush with the rubber friction ring
(1) on the workpiece. To achive this, the spring force of the
spring (3) must be overcome.
✓
The workpiece is now held magnetically.
Note: The GSW-M has a compensating stroke of 9 mm to
protect the machine and the workpiece, thereby the spring
(5) is compressed.
Ø
Lift GSW-M together with the workpiece.
✓
The spring (5) relaxes again by the compensationg stroke.
Release workpiece
Ø
Set down the GSW-M with the workpiece.
✓
The compensation stroke of 9 mm can be used here.
Ø
Apply compressed air or cooling lubricant to the mount (4) to
loosen the workpiece.
✓
While this is happening, the GSW-M continuously dscharges
compressed air or cooling lubricant through the outlet opening.
Ø
Lift GSW-M
✓
Due to the excess pressure in the interior of the GSW-M, the
workpiece is held in a defined position via the rubber friction
ring (1) an its storage position and separated from the mag-
net (2) when picking up by the GSW-M.
