Maintenance
02.01|FDB 150, 300, 340, 660, 900, 1040 |en
63
13 Apply Loctite 222 to the threads of the M3 socket button head
cap screws (9x).
14 Secure the spindle boot and boot ring to the housing using the
9 M3 socket button head cap screws. Tighten to contact plus
one additional flat.
15 Install the air motor assembly as described in
, steps 13 - 27.
Ring Cylinder Assembly FDB 990 / FDB 1040
1 Remove and/or lock-out the spindle motor air supply for safety.
2 Disconnect the air hose from the spindle supply fitting and the
compliance air fitting.
3 Remove the deburring tool from the robot or work location.
4 Clean the debris from the deburring tool using compressed air
and a clean rag to wipe any grease from the outer surfaces.
5 Using a 2 mm Allen wrench, remove the M4 socket head cap
screws (6x) securing the rear housing to the front housing.
6 Remove the rear housing.
7 Using a 2 mm Allen wrench, remove the M4 socket head cap
screws (3x) securing the ring cylinder assembly to the rear
housing.
8 Place the removed M4 screws in the tapped holes in the ring
cylinder body and tighten them slowly and equally, so they
push the ring cylinder assembly out of the rear housing.
9 Apply a thin film of grease or oil to the housing bore where
the ring cylinder seats prior to installation.
8.3.4.4
