SCHUNK 0307330, Сборка и руководство по эксплуатации

Страница: 30 / 52

Assembly and installation
30
02.00 | PW V6 | Assembly and operating manual | en | 389670
5.3 Installing and connecting
Ø
Check the flatness of the screw-on surface, Mechanical
connection [
}
22].
Ø
Fasten the product to the machine/system with screws,
Mechanical connection [
}
22].
✓
Use suitable connecting elements (adapter plates) if
necessary.
✓
Observe the permissible depth of engagement.
✓
Observe the tightening torque for the mounting screws.
Ø
Connect the ground cable between the product and the
machine/system,
Connecting ground cable [
}
31].
Ø
Position the connection cap on the product and tighten the
screws.
✓
Tightening torque: 3 Nm
Ø
Mount connection cap, Installing connection cap [ } 32].
Ø
Connect cable for CAN bus, CAN bus interface [ } 26].
Ø
OR: connect cable for PROFIBUS, PROFIBUS DP interface [
}
28].
Ø
Connect cable for logic voltage, Electrical connection [ } 24].
Ø
Connect cable for power supply, Electrical connection [ } 24].
Ø
If applicable: connect multiple products to each other,
Combination of multiple products [ } 33].
Ø
Set terminating resistor for CAN bus or PROFIBUS on the last
product,
CAN bus interface [ } 26] and PROFIBUS DP interface [ } 28].
Ø
Start up the product, Commissioning the product [
}
34].
✓
Logic voltage LED lights up.
✓
Motor voltage LED lights up.