Faults
10
Actions in case of faults 10.1
Table saw BS-350 LST, BS-400 LST-E230, BS-400 LST-E400, BS-500 LST
67
/80
10
Faults
Faults may only be rectified by trained and authorized personnel. For all
work, the necessary personal protective equipment (workwear, safety shoes)
must be worn.
Work on the electrical connection may only be carried out by qualified elec-
tricians.
10.1
Actions in case of faults
Actions after the occurrence of a fault
In general, the following applies:
1.
In the event of faults that pose an immediate danger to persons or
property, immediately trigger the emergency stop button.
2.
Switch off all power supplies and secure them against being turned
back on.
3.
Inform those in charge at the site.
4.
Depending on the type of fault, report the fault to the responsible and
authorized qualified engineer and have it resolved by them.
Action after remedying of a fault
1.
Check all screw fittings for tightness.
2.
Check whether all previously removed protective devices and covers
have been properly installed again.
3.
Ensure that all tools, materials and other equipment used are removed
from the work area.
4.
Clean the work area and remove any leaked substances, such as, for
example, fluids, work substances or the like.
5.
Make sure that all electrical safety devices (e.g. emergency stop
buttons) of the system are working properly.
