Schulte FX-520, Руководство оператора, Страница: 58 / 166

OPERATION
FX-520 06/16 Operation Section 4-4
© 2016 Alamo Group Inc.
OPERA
T
ION
2. TRACTOR REQUIREMENTS
The tractor used to operate the cutter must have the power capacity to lift, pull, and operate the Power Take
Off (PTO) at 1000 revolutions-per-minute (RPM) while traveling at a ground speed between 2 and 5 mph.
Operating a cutter with a tractor that does not meet the following requirements may cause tractor or cutter
damage and be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
• ASABE approved Cab with Protective Structure and seat belt.
• Tractor Safety Devices .......................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
• Tractor Horsepower -Minimum............... 100HP (75kW)
• Drawbar.................................................. 16” and 20” (406 and 508 mm) length for 1000 RPM unit, rated to
carry weight of mower, safety chain attachment point
• Drawbar Vertical Load Capacity -Min. .... 2865 lbs (1300 kg)
• Hydraulics .............................................. 2 Double acting circuits @2000 psi (13.8 MPa)
• Front End Weights.................................. As needed to maintain 20% weight on front axle
• Power Take Off....................................... 1000 RPM (21-spline 1-3/8” diameter output shaft)
1000 RPM (20-spline 1-3/4” diameter output shaft)
2.1 ROPS and Seat Belt
The tractor must be equipped with a Factory Cab and seat belt to protect the operator from falling from the
tractor and being crushed or run over by the tractor and/or implement resulting in serious injury or death. Only
operate the tractor while seated in the operator’s seat with the seatbelt securely fastened around the operator
OPS-U- 0051
2.2 Tractor Safety Devices
If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO
with the PTO master shield missing or in the raised position.
OPS-U- 0004