24
4.10 Function and parking handbrake
(only on the combination sub-frame)
Attachment to the sub-frame
1. Clip the round end of the
brake cable (
A
) into the bracket on the
base frame (
B
).
2. Pull the cable housing (
C
) forwards
and down, then clamp it into the
rear end of the bracket.
To dismantle the function and locking brake,
follow the previous steps in reverse order.
If the cable housing (C) cannot be pulled back far
enough s that it can be inserted into the bracket,
turn the lock (E) below the function and locking
brake in a clockwise direction!
Settings
To set the brake, release the lock (
E
) and/or
tighten this until the required brake effect is reached.
A gap of approx. 1.5 mm should remain between the rear wheel and brake body!
The function and parking handbrake can only be used on the combination
sub-frame (see
Point 3.2.2
) and in connection with the padded armrests
(see
Point 4.6
) and the lower arm pads. With
the aid of the function and parking handbra-
ke, the
dynamic pacer
can on the one hand
be braked during walking. To do this, pull the
white lever (
D
) to the rear in the direction of
the armrest. On the other hand, the walking
trainer can also be secured against inadver-
tent rolling away. To do this, push the white
lever (
D
) to the front to activate the parking
brake.
4. Accessories.
A
C
B
D
E
Содержание rifton dynamic pacer
Страница 1: ...Instructions for use dynamic pacer The dynamic gait trainer dynamic pacer ...
Страница 42: ...42 Notes ...
Страница 43: ...43 Notes ...
Страница 44: ...schuchmann de GA 33 EN_1 0 ...