08
3. Settings.
3.2 Seat height
fridolin 1.
: To adjust the seatr height,
loosen the clamps (
B
) on the uprights
and bring the seat pan into the re-
quired position. The height of the gas
pressure spring must then be adjusted.
To do this, loosen the two screws (
C
) in
the centre between the two uprights
and adjust the gas pressure spring to
the required height. Firmly tighten all
screws again. If the seat height is ad-
justed in height over 5 cm, the moun-
ting plate for the gas pressure spring
must be turned. To do this, remove and
install the screws (
C
) in the centre bet-
ween the two uprights and the screw
connection for the gas pressure spring
(
D
). Firmly tighten all screws.
fridolin 2.
: The sub-frame can be lowered via the gas pressure spring with
the aid of the height ajustment to low
table heights. To do this, the foot pedal
(
E
) on the right-hand side of the base
frame is operated (in driving direction)
and the seat pan slides down; assist
movement through the application of
slight pressure from above if required.
To move the seat pan upwards, press
the foot pedal again and assist mo-
vement through application of slight pressure upwards if necessary. The foot
pedal can be secured against inadvertent operation with a lock located on
the inside of the foot pedal. To do this, pull on the knurled knob (
F
), turn it to
the right as far as it will go and then release it again. Now the foot pedal is
secured against inadvertent operation. The locking mechanism is released
by pulling on the knurled knob (
F
) again and turning it to the right.
For safety reasons, the adjustment may only take place when no-one is on
the product!
A
B
C
D
E
