L-014124-04
5
Battery capacity failure
If the emergency light unit detects during a operational life test that the capacity of the emergency light
battery is insufficient to maintain the light fitting for the nominal operating time in the case of an
emergency, the signal LED will display a red blinking light.
An emergency battery that no longer has sufficient capacity must be replaced immediately (see
Section 6.3).
The display indicating a fault in the battery capacity can only be reset by means of a successful
operational life test.
Battery contact failure
When the electrical connection between the emergency light unit and the emergency battery is broken,
the signal LED will display a red flashing light.
A battery contact failure and its signal are automatically reset as soon as the connection between the
emergency light unit and the battery is re-established.
2.4 LED-Signals
The two-colored LED (red/green) which is integrated in the reflector of the light fitting does show the
working condition and the error state of the fitting.
The following states are possible:
Continuous green light:
Permanent charging mode
–
light fitting at mains operation,
the emergency battery is being charged
Blinking green light:
Functionality test or operational life test (check of the
capacity of the battery)
Alternating green and red light:
Light fitting deactivated / remote cutoff switch
Red flashlight:
Battery failure
–
the battery is not connected to the emergency
light unit
Blinking red light:
Insufficient capacity of the battery
–
the battery must be replaced
Continuous red light:
LED failure
Acknowledgement light:
Indicator signal in lighting models with battery box that
battery change was successfully carried out
means:
red light for ½ second, green light for ½ second
and no light for ½ second
Содержание e864 12L Series
Страница 15: ...L 014124 04 15...
