SCHOTT KL 200 LED, Руководство по эксплуатации, Страница: 17 / 40

KL 200 LED – Operating instructions
PI_69
7/10
2.3 Power connection
Insert the hollow plug of the supplied power cord into the
plug-in socket (4) of the light source.
Please take care to ensure that you only operate your KL
200 LED light source with the power cord provided.
The plug connection of the power supply is interchangeable
for the EU, UK, US or AU. This is connected to the mains
supply (100-240 V AC, 50-60 Hz).
2.4 Start-up procedure
Switch on/off the KL 200 LED by pressing the switch (3).
When the instrument is switched on the green control light (2) is lit.
Please disconnect power by pulling out the power plug.
2.5 Light intensity setting
The brightness can be adjusted continuously by turning the
light intensity setting knob (7).
Five-step intensity control is possible, from 0 – 5.
The highest brightness is reached at the end stop at
position 5.
When the brightness control is set at 0 there is no more
brightness, i.e. the lamp is off.
Attention: Please note that when the brightness control is
set at 0 the instrument is not switched off. When the
instrument is switched on the green control light (2) is lit. To
switch off the KL 200 LED press the on/off switch (3) once
(see point 2.4 “Start-up procedure”). Please ensure safe
power disconnection by pulling out the power plug!