5
Installation (continued)
www.schonsimplymodern.com
Please contact (800) 880-8164 for further assistance.
Front
Cold inlet
supply line
Hot inlet
supply line
B
C
D
1
2
1
D
E
F
G
1
3
Attaching the mixer to the
standpipe
□
Attach the mixer (C) to the standpipe (D), make
sure the prongs (1) on the standpipe (D) insert
into the hole (2) of the mixer (C).
□
Install the set screw (B) and tighten into the
standpipe (D) with hex wrench.
4
Securing the standpipe
□
Locate the assembly on the desired location with
the flexible tails (1) through the prepared hole
and then holding the escutcheon (E), secure the
standpipe (D).
□
If mounting into wooden floor, secure the
standpipe (D) using screws (F) only (wall plugs
are not needed). If mounting into solid floor,
mark the position of holes first and then secure
the standpipe (D) using anchors (G) and screws
(F). Where requried ensure correct anchors for
your floor type are used.
NOTE:
Do not to reverse the cold and hot supply.
