SCHOLTES SPY1S, Руководство по эксплуатации

Страница: 4 / 20

3
EN
Installation Instruction
Electrical Installation
Appliance must be correctly installed to ensure electrical
safety. During fitting and maintenance operations, the
appliance must be unplugged from the electrical grid. Fuses
must also be switched off or remove. The electrical
connections are made before the appliance is installed in its
housing.
Please ensure:

the electrical installation has sufficient voltage,

the electrical wires are good in condition
,

the diameter of the wires complies with the installation
requirements.
Appliance must connect with a power cable (standardized)
with three 1.5mm
2
conductors (1 ph +1N + ground) that must
be connected to monophase 220-240V network via a
standardized receptacle 1 ph +1N + ground lead or an all-
pole cut-off device in accordance with installation rules.
Warning
We will not be held responsible for any accident
caused by non-existent, defective or incorrect
earthling.
If the electrical installation in your residence requires
any changes in order to hook up your appliance, call
upon a professional electrician.
If any malfunction occur, unplug the appliance or
remove the fuse corresponding to the sector where the
oven is hooked up.
Warning
The safety wire (green-yellow) is connected to the
appliance’s terminal and must be connected to
the earth terminal of the electrical set-up.
You must enable the appliance to be disconnected
from the supply network after installation.
Disconnection can be enabled by ensuring that there
is an accessible power plug or by incorporating a
switch into the fixed wiring in compliance with the
installation rules. If the power cable is damaged, it
should be replaced by the manufacturer, its after-sales
service department or a similarly qualified person to
avoid danger.