SCHOLTES SOTH1900B, Руководство пользователя

Страница: 31 / 37

31
3.2 Turning on/off
Press the on/off button “ T1 “ for a second and the hood will turn on at speed
1.
To increase the speed (2, 3, 4/intense), press the “+” button ( T3) .
To reduce the speed, press the “-” button (T2) (4/intense, 3, 2, 1).
Note: The “Booster” function (intense) lasts for 5 minutes before automatically going back down to speed 3. The display will
show a flashing “4” for 5 minutes. It will then show the number “3” without flashing when it goes back down to speed 3.
To turn the hood off, press the on/off button “ T1 “.
It will be turned off no matter which speed it was on.
Note: To clean the hob without turning the hood on, press the “-” button (T2 ) for 5 seconds.
This will lock the control panel for one minute so you can clean the surface.
The display will show “ C ” throughout this minute. After this, the hood will start working as normal.
3.3 “Delayed stop” function
This function lets the hood turn off automatically after a set time.
Choose the hood speed you want. Press the button “ T4 “. The display “ D “ will show a flashing “ 1 “ and a decimal point. The
decimal point shows that the “Delayed stop” function has been activated.
Use the “-” (T2 ) and “+” (T3) , buttons to choose the delay as follows:
1= 5 minutes
2= 10 minutes
3= 15 minutes
4= 20 minutes
Press the button “ T4 “ to confirm your choice.
Note: You can change the hood speed using the ”-” (T2) and “+” (T3 ) buttons. You can turn the hood off manually using the
on/off button (T1).
You can also change the set delay by pressing the button ( T4 ) again and setting the new delay. It will start counting from 0
again.
When the “Delayed stop” function is active, the display will alternately show the chosen hood speed for 5 seconds followed by
the delay for 5 seconds. The delay will flash.
4. HOW TO CARE FOR THE HOOD
4.1 Cleaning the grease filters
The grease filters must be cleaned when the display shows the letter “ G “ (after 30 hours of use). To reset the display, press the
“+” button ( T3 ) for 5 seconds with the hob off.
4.2 Replacing the carbon filter
The carbon filters must be replaced when the display shows the letter “ S “ (after 120 hours of use).
To reset the display, press the “+” button ( T3 ) for 5 seconds with the hob off.
Note: The message will appear even if the vent is not being used on “recycle” mode. If this happens, clean the filters as normal and
reset the display.