29
4. MAINTENANCE
Always disconnect the hood from the mains before carrying out any maintenance
or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that are designed
to trap particles of fat contained in the fumes.
The metallic anti-grease filters must be washed at least once a month or, if present in
this model, when indicated by the electronic notice, with detergent in hot water (or in
the dishwasher).
The filters may discolor after a few washes, this is normal and does not mean they
have to be replaced. To remove the grease filter, open by pulling down the lower panel
of the hood and then remove the grease filter using the special handle
(Fig. 6).
To reinstall the anti-grease filter, reverse the operations.
It is advisable to refit the grease filters only once they are dry.
ATTENTION: the grease collected in the filters can easily catch fire and it is
therefore extremely important to clean the metallic filters on a regular basis
as per instructions.
The Plasma anti-odor filter does not require any maintenance and its duration is about
10 years while maintaining its efficiency in eliminating the virus, odors and bacteria in
the air.
The hood features a LED light that, in addition to offering a good lighting and a
significant energy savings, are guaranteed to last on average 10 times more than
traditional lights. For replacement, contact the Assistance Service.
In order to remove the remaining glue or any impurity, the cooker hood must be
cleaned immediately after installation and after having removed the protective film.
The cooker hood must be cleaned frequently both internally and externally (at least
once a month).
Do not let dirt gather on the inner and outer surfaces of the hood.
To clean the exterior of the hood do not use either acid or basic products, or abrasive
sponges.
Clean the hood with a sponge dampen in warm water and a little quantity of neutral
detergent (for example dishwasher detergent), in order to remove possible particles of
grease.
Rinse with a damp cloth, removing all the detergent carefully, following the satin finish
direction on the steel surface.
Drying is very important, especially in areas where water is particularly hard and leaves
limestone.
Содержание SOHD1600B
