SLA
9
GB
Adjusting the locking mechanism:
1. Depressurise the hose and retract until
the stopper (item 04) is resting against
the stop.
2. Unscrew the screws (item 07).
3. Remove the cover cap (item 06).
4. Adjust the locking mechanism according
to the instructions in the illustration for
the relevant device:
SLA 8A (Fig. 5a)
SLA 9A and SLA 10A (Fig. 5b)
1= Locking mechanism on
- Strain on hose is relieved
2= Locking mechanism off
- Hose under constant strain
5. Attach the cover cap (item 06) using the
screws (item 07)
9
Maintenance
Keep the air hose free of dust, grease and
dirt.
10
Decommissioning
Storage:
Clean, dry, free from dust, above
5° C.
Disposal:
Dispose of packaging / machine
according to valid statutory regulations.
11
Troubleshooting
Observe the safety instructions and maintenance instructions!
*For troubleshooting: refer to the information in the "Technical data" chapter“!
***For troubleshooting: read chapter: "Commissioning"!
If necessary, contact our service staff, see last page.
12
Spare parts service
Visit our website www.schneider-airsys-
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.
13
Warranty conditions
Basis for warranty claims:
complete unit
in original condition/proof of purchase.
According to legal provisions, you re-
ceive the following warranty against
material and manufacturing defects:
private use only: 2 years,
commercial use: 1 year.
Problem
Cause
Remedy
A
Hose does not
retract fully
Hose retracted unevenly
X
Unroll the hose and retract even-
ly
Insufficient spring tension
X
Replace the spring
*
Spare hose too heavy
X
Use a suitable spare hose
*
Hose stopper displaced
X
Move the hose stopper to the
correct position
***
B
Locking mechanism
does not work
Hose retractor attached incor-
rectly
X
See Assembly
***
Hose released too quickly
X
Slowly pull out the hose to
the locking position
Locking unit damaged
X
Replace the locking unit
Incorrect locking mechanism
setting
X
Adjust locking mechanism
(Fig. 5a SLA8A,
Fig. 5b SLA9A SLA10A)
***
C
Hose retractor leak-
ing
Damaged hose
X
Replace hose
Loose hose clamps
X
Secure hose clamps or replace
Seal on rotary element worn
X
Replace the rotary element seal