Schneider Airsystems FSP-FP-HTE-1,3, Оригинальное руководство по эксплуатации

Страница: 29 / 62

FSP
II/ 11
GB
2.9 Troubleshooting
Observe the safety instructions and maintenance instructions!
Problem Cause Remedy
A The paint spray is
interrupted or
pulses Hold the gun at an incline X Guide the gun such that the ves-
sel is vertical
Material cap is loose or dam-
aged
X
Screw the material cap tight or
replace the entire nozzle set
(item 10, 11, 12 or 13) (see Fig-
ure 3a-c)
Viscosity is too high
X
Decrease viscosity, use nozzle
set with larger diameter, correct
viscosity
Ventilation in cover or drip
guard (item 09 or 14) is
clogged X Clean (see Chapter 4, 5)
B Spray pattern is
incomplete Air cap (item 11) dirty or dam-
aged X Clean (see Chapter 4, 5) or re-
place complete nozzle set (see
Figure 3a-c)
Paint sticks to the nozzle or
parts are damaged
X
Clean (see Chapter 4, 5) or re-
place entire nozzle set (see
Figure 3a-c)
Nozzle needle is damaged X Replace the complete nozzle set
(item 10, 11, 12 or 13)
C Irregular paint
application with drip
formation Nozzle dirty or damaged X Clean (see Chapter 4, 5) or re-
place complete nozzle set
(item 10, 11, 12 or 13) (see
Figure 3a-c)
Working pressure (flow pres-
sure) too low X Increase working pressure (flow
pressure) Observe maximum
working pressure
*
Viscosity is too high
X
Decrease viscosity or increase
material pressure (item 18)
Air cap (item 11) dirty X Cleaning
D Uneven material
accumulation Working pressure (flow pres-
sure) too high
X
Decrease working pressure
*
Slotted nozzle is loose or dam-
aged X Screw slotted nozzle (item 13)
on tightly or replace nozzle set
Air cap and nozzle are clogged
with paint
X
Clean (see Chapter 4, 5) or re-
place complete nozzle set
(item 10, 11, 12 or 13) (see
Figure 3a-c)
Viscosity is too low X Increase viscosity, use nozzle set
with smaller diameter
Compressor output too small
X
Use different output
rating
*
Spray width too great X Reduce spray width (item 4)