7
3 Initial Setup and Operating Procedure
3.1 Notes Before Starting Measurement
Have you read and understood the Operating Instructions, in particular
Chapter 1 “Basic Safety Notices” ?
You are not permitted to operate the tension meter before doing so.
Before working with the instrument you must put on your personal protective
clothing, if necessary. For example, eye protectors, gloves, etc.
To avoid damage, do not move the center roller by hand.
Tensions that exceed the tension range of the instrument by more than 100%
may cause permanent damage to the measuring spring and must be avoided
under any circumstances.
The ID plate with the serial number and the CE mark as well as the calibration
label (optional) are provided on the rear side of the instrument, the SCHMIDT
Quality Seal are provided on the front side.
Calibration label
(option)
SCHMIDT Quality Seal
ID plate with serial number
3.2 Operating Elements
1 MEASURING ROLLER
2 GUIDE ROLLERS
3 MEASURED MATERIAL
4 FILAMENT GUIDE
5 ON / OFF / ZERO key
6 DAMP key (damping)
7 DISPLAY
8 DRÜCKER
1
2
3
4
5
6
7
8
2
fig. 3.2
