12
Material Setup
Submenu
Settings Menu
Description
Name of the
material
characteristic
curve
—
[character],
[numbers],
[special character]
To enter a name for the selected mate-
rial characteristic.
High alarm limit
—
[000] - [999]
If the set limit value is exceeded, the
display reads MAX-ALARM.
Low alarm limit
—
[000] - [999]
If the value falls below the set limit
value, the display reads MIN-ALARM.
Calibration
Chapter 3.6.2
Start
To perform a calibration, follow the in-
structions shown on the display.
Cal. Points
between [5 %] and
[90 %] of the
tension range
Set three calibration points for which a
calibration should be performed.
Weights
[cN],
[g]
Set the unit of the calibration weights
used.
3.4.1 Material setup menu
In the material setup menu you can make the settings for the selected material characteristics
and perform the calibration. To perform the calibration, the weights for the selected calibration
points must be available.
Factory settings are illustrated bold
3.4.2 Factory reset
A factory reset resets the tension meter to its original manufacturer settings. This proce-
dure will delete all settings, including any customer-defined material characteristics
(calibrations); the factory calibration, however, will be kept.
Customer calibrations will be deleted.
