23
4 PC Communication (USB Interface)
4.2 WINDOWS Terminal Program
The measured values and the memory contents can be transmitted over the USB interface
to a personal computer.
You can connect the computer to the INTERFACE of the KXE by using the EK-0662 spe-
cial cable which is available as an accessory.
Requirements
:
A communication program, such as Terminal or HyperTerminal (provided on MS Windows
Version 3.0 or later), must be installed and configured on the computer.
5 Service and Maintenance
The tension meter is easy to maintain. Depending on operating time and load, the
tension meter should be checked according to the locally applicable regulations and con-
ditions (as described in Chapter 3.7). The use of other test methods than the procedure
described in Chapter 3.7 may cause deviating measuring results.
5.1 Rollers
You should regularly inspect the rollers to assure that they are running easily and
smoothly. The
rollers
can only be changed by the manufacturer.
Commands for communication with a PC
(polling)
ASCII
Code
Function
Description
s
Send
Transmission of the undamped reading.
d
Send
Transmit current reading to PC once.
r
Output
Output the memory contents to the PC.
4.1 The TENSION INSPECT 3 Program
The Tension Inspect software from SCHMIDT is described in a separate user manual.
The requirements of the CE specification are only complied with if the ten-
sion sensor is equipped and operated with display units and connecting
cables supplied by HANS SCHMIDT & Co GmbH. Certification to the CE spec-
ification does not extend to, and shall be invalid for any other combination.
Under no circumstances shall HANS SCHMIDT & Co GmbH be held liable for
any damage resulting from the use of non-SCHMIDT sensors or cables.
