Operating / Assembly manual
30
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
Pump type WK/ SMK
Version: 27220 - E
Note:
Before initial commissioning and after an extended down time, or after installation of a
new mechanical seal, always check for smooth operation.
Due to adhesive forces, the slide ring and counter ring may cling together strongly. When this happens,
the driving spring does not have sufficient traction to break the slide ring free. Then the shaft runs into
the fixed seals and driving spring, which results in damage. Remove the fan hood and rotate the fan
wheel in the direction of the arrow indicating direction of rotation. If you encounter resistance and the
fan wheel springs back, the mechanical seal must be removed and the slide and counter rings must be
carefully separated.
Try not to rotate the shaft forcefully.
10.2.
Disposal
If you want to shut down the pump permanently and take it out of operation, observe local regulations
for disposal of industrial waste.
10.3.
Important Information
10.3.1.Factory Repair
1.
If you send the pump in to the manufacturer's plant for repairs or modifications, include exact
information about the medium pumped by the pump (safety sheet).
2.
Only completely emptied and cleaned pumps are accepted for repair.
10.3.2.Ordering Spare Parts
When ordering spare parts, always specify the following important information:
Pump number and type designation, alternatively the motor number
Pumping medium
Item number / name of the part from the spare parts list
Material information from the specification or confirmation of order
You will find the pump number on the nameplate, which is fastened onto the fan hood of the motor.
The confirmation of order or motor number may also be helpful. This will help us deliver the right spare
part for your pump!
10.3.3.Customer Service:
Address of main office:
Schmalenberger GmbH + Co. KG
+49 (0)7071 70 08 – 0
+49 (0)7071 70 08 - 10 (Fax)
www.schmalenberger.de
Im Schelmen 9 – 11
D-72072 Tübingen / Germany
